10 Industrial Electrical Training Video Course Library -

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Megger test procedure – phase-to-phase & phase-to-ground | Acceptable values for 480V motor | | 2 | Surge comparison test for turn-to-turn shorts | Compare good vs. bad waveform | | 3 | Motor bearing types & replacement (grease vs. oil) | Pull a bearing with a puller | | 4 | Shaft alignment – dial indicator vs. laser alignment | Demonstrate soft foot | | 5 | Analyzing failed windings – overload, single-phasing, contamination | Show 5 failed stator photos |

Identify correct PPE for a Category 2 arc flash hazard. Course 2: Multimeter & Electrical Test Equipment Focus: Proper use of DMMs, clamp meters, insulation testers, and voltage testers. 10 Industrial Electrical Training Video Course Library

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | NFPA 79 (Industrial Machinery) – key requirements | Panel labeling, wire colors | | 2 | Panel layout – component spacing, heat dissipation, wireways | Redesign a crowded panel | | 3 | Grounding & bonding – ground bar, shielded cable termination | PE terminal to backplane connection | | 4 | Wire types (MTW, THHN, TFFN) & ampacity tables | Select wire for a 30A circuit | | 5 | Short-circuit current rating (SCCR) of an assembled panel | Nameplate calculation example | | Segment | Topic | Key Demo |

Focus: NFPA 70E, arc flash, lockout/tagout (LOTO), and hazard recognition. laser alignment | Demonstrate soft foot | |

Fix a VFD tripping on “Overvoltage” during deceleration. Course 8: Electrical Schematics & Panel Troubleshooting Focus: Reading industrial drawings, finding shorts, opens, and ground faults.

Using a schematic, find why a pump will not start – all indicators are off. Course 9: Electric Motor Maintenance & Failure Analysis Focus: Megger testing, bearing replacement, alignment, and winding evaluation.